DMS Software Specification

Copyright

Copyright Creare LLC 2016. This specification document is proprietary and should be considered confidential. Reproduction or distribution prohibited without written permission from Creare.

Contents

• 1. Functional Specification
  • 1.1. Introduction
  • 1.2. Interface
  • 1.3. Fault Detection
  • 1.4. Fault Thresholds
  • 1.5. Reference Mode
  • 1.6. Subtleties
  • 1.7. Testing Results
• 2. Firmware Specification
  • 2.1. Copyright
  • 2.2. Revision Log
  • 2.3. Introduction
  • 2.4. Identification
  • 2.5. Laser Power
  • 2.6. Alignment
  • 2.7. Recording Raw Data
  • 2.8. Global Parameters
  • 2.9. Calibration
  • 2.10. Extracting Signals
  • 2.11. Monitor Dispense
  • 2.12. Computing Features
  • 2.13. Fault Detection
  • 2.14. Set Reference Dispense
  • 2.15. Return Fault Data
  • 2.16. Expose Parameters to Host
• 3. Interface Control Document
  • 3.1. Copyright
  • 3.2. Revision Log
  • 3.3. Introduction
  • 3.4. USB Interface
  • 3.5. Endpoint 0 Commands
  • 3.6. Status
  • 3.7. ID
  • 3.8. Config Get
  • 3.9. Config Set
  • 3.10. Calibrate
  • 3.11. Get Calibration
  • 3.12. Store Calibration
  • 3.13. Monitor Dispense
  • 3.14. Get Dispense Data
  • 3.15. Clear History
  • 3.16. Set Reference Dispense
  • 3.17. Get Well Faults
  • 3.18. Stream
  • 3.19. Firmware Block
  • 3.20. Firmware Program
  • 3.21. Firmware Get CRC-32
  • 3.22. dmsCodes.h
• 4. Interface Specification
  • 4.1. Copyright
  • 4.2. Revision Log
  • 4.3. Overview
  • 4.4. Host
  • 4.5. Configuration GUI
  • 4.6. BioTek Application Interface
  • 4.7. Development Interface
• 5. Development Interface
  • 5.1. Overview
  • 5.2. Installation
  • 5.3. Connecting to the DMS
  • 5.4. DMS Calibration
  • 5.5. Setting Configuration Parameters
  • 5.6. Dispense Monitoring
  • 5.7. Plotting Previously Acquired Data
  • 5.8. Updating Firmware
  • 5.9. Performance Monitor